Yokomo YD-2 2WD RWD Drift Car Kit (Plastic Chassis)
The Yokomo YD-2 2WD Drift Car Kit features an innovative 4 gear transmission for good throttle response and high rear traction. The design helps to provide great lateral balance with neutral steering characteristics to create more room in the line. The design also features Ackermann settings that help to provide natural steering characteristics. The design helps to provide a full counter steer set up, with easier to drive characteristics.
As a drift car, a 4 gear transmission is an innovative concept. By setting the motor horizontally, it prevents neutral steering characteristics by preventing the left-right balance from collapsing due to the counter torque of the motor. On the other hand, since the rear traction increases with the throttle ON, it is possible to create an additional sense of stability and acceleration during corner exit. The enclosed type gear box is also attractive for its high dust resistance.
High Angle Steering
The high angle steering design helps to prevent the rear from unloading and stalling less during cornering. Of course, you can change the installation position of the tie rod to change the feel according to driver preference and the surface conditions.
The composite main chassis draws the best traction balance with moderate stiffness. Drift running with a hard tire may cause a reduction in traction due to vibration, but the resin chassis can improve the feeling by absorbing vibration. By changing the battery holder, it can fit a full-size straight pack or a short Li-po battery.
The composite oil shocks offer smooth operation with a high level of ground contact. You can adjust the ride height by rotating the spring tensioner, and the shocks are compatible with springs of various lengths. By adjusting the damping force by changing shock oil and piston, optimum settings can be obtained to suit the surface and driving style.
NOTE: Wheels, tires, and electronics shown in photos are for illustrative purposes only and are not included. See needed to complete list below for a full list of items required to complete the model.
- 4 Gear rear transmission
- Re-designed closed gear box
- Four wheel independent independent wishbone suspension
- High performance vehicle height adjustment type oil damper
- Resin one piece main chassis
- Aluminum motor mounting plate
- RWD exclusive high angle steering system
- 49 mm Born rear universal shaft
- Re-designed narrow scrub knuckle
- Large rear diffuser
Total length: 425 mm
Full width: 198 mm
Wheel base: 256 mm
Secondary reduction ratio: 1: 2.6
All equipment weight: 1500 g
Needed To Complete:
- 2-Channel radio system
- Electronic Speed Control
- 540 Motor
- Steering servo
- 7.4V LiPo battery pack
- Compatible battery charger
- Drift car tires & Wheels
- 200mm TC or Drift body
- Polycarbonate paint for body
This product was added to our catalog on August 2, 2017.