Prime B5M Waterfall Brace & Fan Mount (Hard)
PRI2002
This item is discontinued and no longer available for purchase. You may want to search our site for a similar item.
The Prime B5M "Hard" Waterfall Brace & Fan Mount is a 3D printed waterfall brace that creates a perfect spot to mount a 30mm fan and keep your motor cooler in the heat of competition. The mount uses 3x10mm flat head screws to mount the brace to the chassis and 3x10mm button heads to secure the upper mount to the transmission case. The mount uses 3x16mm hardware to mount a 10mm thick fan, or 3x20mm hardware to mount a 15mm thick fan. Package includes waterfall brace. Hardware not included.
This product was added to our catalog on November 10, 2015
Anonymous
Verified Owner
Thursday, Jun 23 2016 (about 7 years ago)
Prime B5M Waterfall Brace & Fan Mount (Hard)
DO NOT WASTE YOUR MONEY ON THIS!!!! IT DOESN'T FIT!!! The measurements are all wrong for your sc5m/B5m. Its to tall and leaves a 1/8" not quite a 1/4" gap between the trans and the top of the brace. If you try to tighten it down you strip the screws out of the plastic and puts too much pressure on the bottom screws holding the trans in at the bottom. SERIOUS FAIL FOR THE PEOPLE PRINTING THESE DID YOU NOT MEASURE THE ORIGINAL!?!?!?! NOT EVEN CLOSE DUDE
Richard Driggers
Verified Owner
Thursday, Sep 20 2018 (about 5 years ago)
Prime B5M Waterfall Brace & Fan Mount (Hard)
I read the previous review and was hesitant to purchase this 3D printed waterfall part, for my T5M, thinking this might be a waste of money. The part arrived and I was impressed with the quality and fit. I measured the factory stock to the 3D printed part and they were a perfect match for the installation. The only difference was the thickness of the top plate that mounts to the top of the transmission.