This item is discontinued and no longer available for purchase. You may want to search our site for a similar item.
This is the Lynx Heli Blade mCP X BL Main Head Grip Set Service Bag. This package includes hardware needed to service the LYX0473 and LYX0474 main head grips.
Tips for Best Results:
- Link Ball Diam 2: Remove original link ball using a Micro Flat Screw Driver 0.3mm and heat the ball with a lighter or soldering iron to make removal easier. Remember to add thread lock to the new linkage balls before installing and do not over tighten.
- 2x5x1.5mm Radial Bearing: Original bearings are installed with thread lock compound. The easiest way to remove the bearing is to boil in water for 5 minutes, then use smaller pliers to loosen it and use a 1.5mm hex screw driver to pass through the bearing holes and push out the bearing. Dry and clean the parts before installing the new bearing. Use a thin layer of Blue thread lock around the outside bearing ring and insert the bearing using the same method used to remove it. To push the bearing in place, use a 3mm hex screw driver.
- O-Ring Silicone Red: Push carefully with fingers over the link ball; don’t use tools as this could damage the o-rings.
Includes:
- (2) Link Ball Diam 2
- (4) 2x5x1.5 Radial Bearing
- (2) O-Ring ID 1 - W1 Silicon Red
- (2) Countersunk Pan Head Screw M2x8
This product was added to our catalog on September 16, 2013