The Exclusive RC RC4WD V8 LS Edelbrock Intake Manifold gives you more custom build options for your RC4WD V8! This intake is a true builders accessory, with included coils. All the detailing is left up to you, allowing you to add a personal touch that cannot be duplicated. When finished and installed, this will give your RC4WD V8 a custom look that cannot be matched by the stock RC4WD accessories.
Assembly and detailing required. This should be completed using a thin, fast drying CA glue and short 1.5mm or 1.6mm hardware (4mm or 6mm length is adequate). Hardware not included. These install to the block using the stock hardware, and can be detailed using Tamiya TS, or Testors model paints.
This is printed in carbon nylon filament. Carbon nylon creates stronger parts with finer detail than PLA filament. Plus, carbon nylon sands better and is easier to paint, so you can add more details if you choose.
- 1.6mm should be installed in the intake like shown in the photos as a detail option.
- Photos show a painted and finished intake. This is done for illustrative purposes only. The product you receive is black and unpainted.
- With most 3D printed items, some light finish work may be needed to remove excess material. Simply use a sharp hobby knife to carefully remove small strings and straggler layer lines as needed.
This product was added to our catalog on March 22, 2018