Dynamite 540 Brushed Motor (15T)
The Dynamite 15T Brushed Motor is a great replacement motor for any 15 turn application. The closed end bell design, low maintenance and factory installed wires make it an easy to operate and install option.
Bearings or Bushings: Bushing
# of Turns/Windings: 15T
Voltage: 4.8 - 9.6V
Cells: 4-8 Ni-Cd/Ni-MH or 2S Li-Po
Overall Diameter: 1.42 inch (36mm)
Shaft Diameter: .125" (3.175mm)
Shaft Length: 0.60 inch (15.5mm)
Overall Length: 1.98 inch (50mm)
Needed To Complete:
This product was added to our catalog on August 7, 2015.
Phenomenal motor and an exceptional price. Have purchased two for some o.s. rigs and one for backup. These outperform the mods of the past that ran me upwards of 80 dollars back in the day. They are freakishly fast, responsive, and a more than adequate upgrade to your 27 turn rtr. However, make sure that your ESC can handle the nearly 40% increase in power consumption (lower turn). A very, very inexpensive upgrade compared to the cost of a brushless system. I have been involved in r/c for twenty years and do have modern electronics in new r/c's and I'm impressed with this motor and AMain.)