E-flite 60A Pro Switch-Mode BEC Brushless ESC

This is the E-flite 60 Amp Pro Switch-Mode BEC Brushless ESC. The 60-Amp Pro SB Brushless ESC with Switch-Mode BEC, and advanced programming, allows you to operate up to 7 analog or 6 digital standard-sized servos with the BEC on any recommended input voltage.

Features

• Up to 60A continuous current with proper air flow with 75A peak
• 5V swich-mode BEC circuit capable of 2.5A continuous current on any recommended input voltage
• Drives up to 7 analog or 6 digital standard sized servos, with the BEC, on any recommended input voltage
• 3–6S Li-Po, 9- to 18-cell Ni-Cd/Ni-MH input voltage
• Finned heat sinks
• Programmable motor braking
• Safe power-arm mode prevents accidental starts
• Programmable low voltage cut-off with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V), or 70% of battery starting voltage
• Programmable soft start for helis and airplanes
• Auto motor shut down if signal is lost or there is interference
• Programmable timing—5 user selectable ranges for use with a larger variety of brushless motors
• Programmable throttle input range (1.1ms–1.9ms or 1.2m–1.8ms)
• Utilizes new smaller mosfets technology to minimize weight
• Radio System Power On/Off Switch
• Optional RS232 Serial Link available for programming
• Pre-wired connectors—E-flite EC3 on battery input and 3.5mm female gold bullets on motor output leads

Specifications:
Brake: Yes - Programmable
Continuous Maximum Current: 60A with reasonable cooling
Input Voltage: 10.8V - 22.2V
Input Connector Types: 13 AWG with E-flite EC3 Connector
Output Connector Types: 13 AWG with 3.5mm Female Gold Bullet Connectors
Momentary Peak Current: 75A (15 sec)
Dimensions (WxLxH): 76x33x13 mm (3x1.3x.5 in)
Weight: 66g (2.3 oz)
Wire Gauge: 13 AWG
Cells w/BEC: 3-6S Li-Po or 9-18 Ni-MH/Ni-Cd

This product was added to our catalog on January 11, 2008