Avid RC Carbon Fiber Rear Hub Tower
This is an optional Avid RC Carbon Fiber Rear Hub Tower, and is intended for use with the Team Associated B4, B4.1, T4, T4.1 and SC10 1/10 scale vehicles. These hub towers are a great upgrade for any Team Associated vehicle running the blue aluminum rear hubs featuring lightweight 3mm Carbon Fiber and additional camber locations.
- 2-in-1 High and Low Outer pivot locations: Without changing parts, racers can run the standard kit upper link location “A” tower, or try dropping the outer pivot height 2mm with a ground rear u-brace like the “C” tower. Both adjustments are included on the same part!
- Lightweight 3mm carbon fiber composite. 2.2g per pair
- Additional buggy wheel clearance compared to molded plastic hub towers
- 3/16” aluminum locking nuts and washers included.
Material: 3mm Carbon Fiber
Weight: 2.2g per pair
- (1) pair of hub towers
- (2) 3/16” aluminum nuts
- (2) black oxide washers
- (1) Avid mini decal sheet
- To evenly disperse the load of the nut so weird hits don't harm the tower, put the washer on right before you put on the nut .
- These Carbon Fiber Hub Towers fit the aluminum rear hubs (ASC9864, ASC9865, ASC9866, ASC9867) and contain the standard setup locations used on the “A” and “C” towers. Typically the 2mm lower rear link position is used on the B4 rear for smooth indoor tracks. It is also commonly used on the T4 for all conditions.
This product was added to our catalog on October 23, 2012.