XRAY XB4 Aluminum Rear/Rear Lower Suspension Holder (Updated)

The rear hinge brace is machined with an offset to the right, creating uneven rear toe. With zero inserts, when measured with precision equipment in relation to the centerline of the chassis, it gives you 2.5 deg right/3.5 deg left. The '14 is apparently the same. Xray refuses to acknowledge an issue, but virtually every person that we have pointed this out to has confirmed it. It is even visible by eye! The car is great, but you have to mis-match rear inserts to make the rear symmetrical. A Hudy setup station will not show this, as it only measures in relation to the other wheel, not the centerline of the chassis, (you could mount the rear end sideways and the setup station would still show the same reading) I understand there are sometimes issues in manufacturing etc., but Xray's transparent BS replies on the forums and in emails, and complete refusal to acknowledge this, leaves a pretty awful taste in my mouth. Go ahead and do the research, we've been discussing it at length on the popular forum, there are a couple other issues, but this is the one that stands out. The car is still good, and things can be done to compensate, but Xray themselves has earned my bad review.

This is not machined correctly! The holes are off center.

CATION: this part is incorrect and xray refuses to fix it. This will leave your rear toe set incorrectly. Xray needs to update this part asap.