XGuard RC XGlow Pro Throttle Signal Pickup Cable Set
AAVXG0203
Back Order Now
$2.99 flat rate shipping!
Learn More
This item earns up to 8 VIP Reward Points
Learn More
The optional XGuard RC XGlow Pro Throttle Signal Pickup Cable allows users to add "Anti-Hot Start" to their XGuard equipped nitro helicopter. Installation is simple by inserting the silver pin into the XGlow servo connector, and the opposite side (side with 1 single yellow wire) is connected to a Y-Harness that is plugged into the throttle port of your receiver or gyro system.
Once connected, it allows the XGlow to know the throttle servo position to prevent hot starts, and runout prevention when additionally connected to the RPM port of the governor sensor*.
*Note: Runout prevention is only possible with both AAVXG0203, and AAVXG0202 installed to the XGuard.
Once connected, it allows the XGlow to know the throttle servo position to prevent hot starts, and runout prevention when additionally connected to the RPM port of the governor sensor*.
*Note: Runout prevention is only possible with both AAVXG0203, and AAVXG0202 installed to the XGuard.
This product was added to our catalog on December 24, 2020
