Team Associated 12mm Hex Wheel Adapter Set (SC10RS/SC10B)

Read Reviews
Write a Review
Team Associated 12mm Hex Wheel Adapter Set (SC10RS/SC10B)
Price: $4.99
Discontinued Online
This item is discontinued and no longer available for purchase. You may want to search our site for a similar item.
This is a replacement Team Associated Hex Wheel Adapter Set, and is intended for use with the Associated SC10RS. These can be used to convert the standard SC10 to hex drive, but must be combined with the Associated front axle set (ASC9881) and steering block set (ASC9880), as well as Associated 12mm hex wheels.

This product was added to our catalog on August 23, 2011

Anonymous
Verified Owner
Sunday, Mar 2 2014 (about 10 years ago)
Team Associated 12mm Hex Wheel Adapter Set (SC10RS/SC10B)
I bought these adapters to convert my sc10 RTR to an sc10rs per recommendation of what you need. I've used plastic hexes before but none of this POOR quality. The countersunk slot for the axle pin is too deep so when you put the hex adapter on which acts as a bearing race, then install your wheels and snug them down, the tiny plastic bearing race smashes down and locks itself into your axle behind the pin. This destroys the ability to tighten the wheel down enough to remove play and they have to be pried off with a wedge and hammer after a couple days of bashing. This almost cost me my bearings as they were not getting the correct compression with the wheel knocking around. DO NOT BUT PLASTIC HEXES. It is 100% worth getting the ae factory team clamping alloy ones which I have now and they are fantastic. JConcepts would be my next choice if I manage to kill the ae factory ones. I dont see that being possible looking at how stout they are. Clamping hexes are the best. Set screw hexes compromise the integrity of the metal by holding a pressure point under high stress all the time and can cause an axle to snap. I also purchased the JConcepts front axles for this conversion to use with the plastics and now the alloys. I absolutely love these axles. You will use the bearings from your front wheel for the rs hub carrier and the jc axles are machined very clean and stout. They will use the same wheel nuts as the rear of the stock sc10 RTR so get lots of extras. For you rs guys, I don't need to tell you that these are crap. Just a fair warning to those new to the sport like myself.
Christian Rivera
Verified Owner
Wednesday, Jan 25 2017 (about 7 years ago)
Team Associated 12mm Hex Wheel Adapter Set (SC10RS/SC10B)
Extremely cheap , shreds pins really quick . if you need spares somewhere in your box cause you far from home then Yes .
Nelson Osoria
Saturday, Jun 24 2017 (about 6 years ago)
Team Associated 12mm Hex Wheel Adapter Set (SC10RS/SC10B)
Skip these and go straight to aluminum hexes, my rears failed first run out..