Strix Nano Goblin Kit (580mm)

This is a Strix Nano Goblin Kit, featuring a main spar that is 3mm square and travels down the wing well past the servos to give sufficient support. In addition to the main spar, additional carbon fiber is located in each elevon as well as the main body, forward of the motor.  

Power by a Cobra motor is the recommendation, the Strix Nano Goblin has great performance when fitted with a 1407 3500kv motor, this provides efficiency, reliability, and performance to get your Nano Goblin moving! A 10 Amp ESC is needed for this plane, the one which was designed specifically for this plane was the STRIX Nano Goblin Replacement Cobra 10A ESC also gave it a 2 Amp switching BEC so you can comfortably power more than just your servos and receiver. 

Flying the Strix Nano Goblin has been likened to a micro fighter jet. It has no tendency to keep rolling after a control input and prefers to keep going where it was last pointed, without the nose wandering over the horizon. This aircraft stalls gracefully and simply dips its nose. Rolls are on the center axis and it can practically turn onto itself when you need to avoid the next tree line. The Strix Nano Goblin also does not need absolutely perfect conditions to fly well, it remains stable with very little wing wag.

Specifications:

Wingspan: 580mm

Wing Area: ~140" sq

Length: 390mm

Weight: 200-250g (Ready to fly with FPV and battery)

Motor: STRIX Cobra 1407 3500KV (recommended not supplied)

ESC: STRIX Cobra 10A with 2A UBEC (recommended not supplied)

Servos: STRIX Emax ES9051 Digital (recommended not supplied)

Prop: Gemfan Flash 3 Blade 3052 (APC 4.1 x 4.1 can also be used) (recommended not supplied)

Battery: Li-ion 2s 3200mAH or Li-Po 1500-1800mAH 2s (recommended not supplied)

Top Speed: 60mph on stock propeller or 70mph with APC 4.1x4.1(2s li-ion, verified by radar on several passes)

Flight time: Varies with battery, but we typically see 40-50 minutes when having fun using the Li-ion packs, and over 60 is easily possible.

Includes:

• (1) Kit Nano Goblin
• Wings and channel covers are unassembled
• Fuselage halves are unglued
• Control linkage is assembled, but not installed
• Upper and lower motor mount plates and canopy hatch are installed
• (1) Quick setup guide with Decals
• (1) Spar set (front and rear)

Needed to Complete:

• 4 Channel RC transmitter and receiver
• Flight battery
• FPV gear (optional)
• Motor, ESC, Servos, Propeller