SCRATCH & DENT: M2C Racing 17mm SCT410 Hub Adapter (4)
Sold as is, photo of product may not be an accurate representation of product condition. ALL SALES ARE FINAL.
This is a pack of four optional M2C Racing 17mm Hub Adapters, intended for use with the Tekno SCT410 4WD Short Course Truck.
This direct bolt on system provides 17mm hex nuts with a sure lock design that will greatly help reduce the chance of the nut backing off during use. Using the stock pin, the hex nuts are held onto the axle with a small end cap that screws to the 4mm axle, or by using a side load pin hole that is retained by a 3mm set screw.
- (4) 17mm Nuts
- (4) 17mm Hex Adapter
- (4) Retainer Nut
Note: You may not be able to run the 6mm shim with the side load as this is a very close dimension.
This product was added to our catalog on August 29, 2016.