Revolectrix Multi-Port Safe Parallel Adapter (JST-XH/EH)

Discontinued Online
This item is discontinued and no longer available for purchase. You may want to search our site for a similar item.

This is the Revolectrix Multi-Port Safe Parallel Adapter. This adapter is a Multi-Port Safe Parallel Module for safely interconnecting same-cell-count LiPo batteries in parallel; also supports transmitter and receiver NiCds. This version supports LiPo batteries with JST XH compatible balance connectors and wiring, and comes with red/black bare wire for power outputs. Solder the connectors of your preference to each wire pair. Interconnect cables available separately to support Revolectrix Cellpro PowerLab 6/PowerLab 8, Cellpro 10XP, and other charger brands compatible with JST XH balance connectors and wiring. Be sure to purchase the proper cable to plug the adapter into your charger or battery workstation.


  • "Mains" output, safety banana plugs support up to 40A charge/discharge
  • Polyfuse with thermal indicator protects TX/RX or 1S LiPos
  • Connect transmitter NiCd/NiMH
  • Connect receiver NiCd/NiMH
  • Connect two 1S in parrallel for indoor fliers
  • JST XH "input" balance port for daisy-chaining multiple MPA's
  • Rugged ABS plastic tray
  • Glass Epoxy Balance Connector PCB
  • 9 Discrete polyfuses (per port) with thermal indicators protect every cell/wire in every parallel-connected pack; each port supports 2S-8S LiPo packs
  • 6 independent balance ports support one battery each (2S-8S) of same cell-count LiPo battery packs safely connected for parrallel charging
  • Glass-epoxy (3oz. copper) Power PCB; standoff-mounted to keep the heat off the balance PCB
  • JST XH "output" balance port to charge's balance jack. Cables available to support: Revolectrix PowerLab 6, PowerLab 8, Cellpro 10XP, and other JST XH compatible brands
  • Every port fuse protected
  • 12AWG high-stand flexible silicone jacket to support up to 40A charge/discharge

Number of parallel packs supported: 6
Cell range supported: 2S-8S
Max current supported: 40A
Reverse polarity fuses on main charge wires: All packs protected
Safety Self-reseting polyfuses Used: All cells/wires protected
Temperature indicators to warn of problems: All cells/wires protected
Supports 1.25mm single cell "indoor" LiPo batteries: 2 in Parallel
Supports Receiver NiCd/NiMH battery: Yes, polyfuse protected
Support Transmitter NiCd/NiMH battery: Yes, polyfuse protected
Works with Cellpro products*: YES
Works with other brand chargers**: YES
Multiple units can be daisy-chained: YES
Dimensions: 7.92x4.19x1.56 inches (201x106x40mm) *not including cables

*MPA can be used with any Cellpro brand products capable of XH WIRING MODE; e.g., Cellpro 10XP, Cellpro PowerLab series. Cables available to support direct connection to these models.

**Cables also available to support direct connection to other XH compatible chargers. Cables available from other charger vendors will likely not work with the MPA without modification.

This product was added to our catalog on September 19, 2012