Reefs RC 422HDV2 High Torque Titanium Gear Digital Servo (High Voltage)

I had one of these in a 10.3 Gladiator pushing weighted SSD wheels for almost 3 years until it recently died, right before I hit the trails thankfully. I have not been kind to the servo, fully submerged on almost every run, plenty of hard hits from falls/descents, broken C-hub arms but servo kept pushing. I've since replaced the servo with a Raw 500 taken from my E-Revo but I'll be replacing that with duel 422's. Single servo did the job but I found myself breaking steering linkage in the revo a lot since only one side of the steering linkage is supported. Highly recommend servo

Installed this 422 servo on my axial bomber with a reefs servo horn. I've done some basic tests with 2800kv axe system and 3s battery. Hoping that it will hold some rock bouncing. Would change to a servo saver maybe.

My first 422 died after few races when I moved it to my baja rey. It seems the steering bellcrank is crap and got stuck, which obviously sent all the stress to the servo. The servo got stuck from a couple of broken teeth on one or two gears. Did not purchase the replacement gears as it seems something else damaged the servo. My second 422 is installed on my rarely used scx10 III.

It is 2024 and I got a third 422 this time for my baja rey with vitavon bellcrank. Hopefully this one should last more years.

This is my 1st after market replacement servo.(been in and out of the hobby for over 30 years) In the past I have always used RTR servos or the "standard" and replaced them with the same. This time I upped the game and it was well worth it. The 422 is super smooth and way more powerful than the stock servo in my trx 4 that it replaced. I will be adding a reefs to future builds.

I have one of these servos on my SCX 10.2 and boy is it powerful and reliable. Always returns perfectly to center, not very loud, and even at 6 volts it was fast and strong. It's high voltage capable and I run mine at 8.4v and it allows such fine control and strong steering. For sure worth the money if you're considering a bulletproof servo.

very fast servo perfect for the trails a lot tq the best

You get what you pay for, this thing is absolutely awesome.

Have been using this item for a few weeks. No issues, works good. Strong and fast.

I have this Reefs RC servo in another crawler and because I've had no problems with it, I decided to install one in my Capra 1.9 to replace the factory steering servo. So far, I've only had one outing with it but it worked every bit as good as I expected it would, based on my previous experience with the same servo in a Redcat Gen8 AXE.

Servo installed into Arrma Kraton 6s v4. Much more powerful (obviously) than stock. Operates very quietly. I paired the servo with Hot Racing servo mount and the performance is night and day over stock. My ESCs BEC is limited to 7.4v which gives the Reefs plen

Very nicely built Servo with plenty of power and speed for my Tekno ET48 2.0. I haven’t had it long enough to speak on longevity but my initial thoughts are it’s great for 1/8 scale race cars and it’s quite, accurate and smooth. Most likely my new go to servo for 1/8 scale.

Has been great. Tons of power and very quiet. I have it running with a Mamba X on 7.4V and could not be happier. Great value for the cost.