RC Maker 1/8 Off Road Digital Camber Gauge
The RC Maker 1/8 Off Road Digital Camber Gauge is a first of its kind setup tool that allows you to fine tune your camber and camber gain settings on 1/8 buggy and truck applications. This helps give you peace of mind knowing you are using an accurate tool to replicate a setup measurement. You can use it on standard wheels, setup wheels or in combination with a setup station to give you true and incredibly accurate camber angle measurements. It allows infinite fine tuning, allowing you to adjust your camber to the optimum point of perfect tire wear and traction. It even includes a protective velvet pouch to ensure it stays safe during storage, and a AAA Battery for power.
Use to Measure:
- Camber Gain: Camber-gain is a measurement that cannot be accurately read on a setup station. The RC Maker gauge allows you to further fine tune your roll center and camber-link settings to find the optimum amount of camber gain. The amount of camber gain can be calculated by taking your camber at ride height and subtracting your camber under compression. The difference between these two angles is your camber gain, and has a massive impact on the handling of the car and wear of the tires.
- Measure Front & Rear Toe: This gauge can also be used to monitor and adjust your front and rear toe! Holding the car vertically on the setup board, with both wheels touching your setup board, you can achieve a very accurate measurement of your front and rear toe as well as true inside and outside steering locks.
- Tested & Proven Accuracy: The accuracy of this gauge is incredible. Several angles are referenced to ensure precise and consistent accuracy. Testing has shown that all devices are within 0.01 degree tolerance across a 3-degree range which it is regularly used on touring cars. All Camber and Toe Gauges are tested prior to selling and perfect calibration is ensured every time.
- Zero Function: The gauge does not require a level surface and can be used on any angle pit bench/setup board, because the “zero” function allows it to zero to whatever angle surface you are working from. Zero it on your pit board before use, and you will have accurate measurements all day long!
This product was added to our catalog on December 8, 2017.