ProTek RC HV LiPo Receiver Battery Pack (Mugen/AE/8ight-X) (7.6V/2200mAh) (w/Balance Plug)

Read Reviews
Write a Review
ProTek RC HV LiPo Receiver Battery Pack (Mugen/AE/8ight-X) (7.6V/2200mAh)
Back Order Now
You may back order this item and it will ship when it arrives.
Price: $39.99

Please Log in to receive a notification when this item arrives in stock.

Save In List
This item earns up to 40 VIP Reward Points Learn More

ProTek RC High Voltage Surface/Air Receiver Battery

The ProTek R/C 2200mAh HV LiPo Receiver Battery Pack brings LiHV power to your servos! This battery is a direct fit in Mugen and Team Associated 1/8 scale battery boxes, and will provide improved power and response from your HV servos.

These packs are built with a Lexan plastic shell around the outside of the battery, and then covered in blue heat shrink. The Lexan shell is designed to protect the battery cells while in the vehicle, for longer life. Note that due to the Lexan shell, sometimes the battery may feel soft to the touch on the outside of the battery; this is normal as there is a small air gap between the Lexan shell and the battery cells inside.

Features:

  • Direct fit for 1/8 Losi 8IGHT and 1/8 HB battery boxes
  • Works great Helicopters and Airplanes as well!
  • Built in Lexan shell for added protection
  • Great for HV servos!

IMPORTANT LITHIUM POLYMER SAFETY INFORMATION

  • DO NOT leave a battery in your model when charging
  • DO NOT leave lithium batteries unattended when charging
  • ALWAYS balance charge lithium battery
  • ALWAYS use a LiPo Safe charging bag/box
  • YOU MUST use a Li-Poly specific charger to charge lithium batteries (NiMH or NiCD only chargers WILL NOT WORK!)
  • YOU MUST not over discharge lithium battery packs
  • READ & UNDERSTAND the instructions carefully before operating this battery

NOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in overheated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for the first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not use a battery that has too low a voltage. Do not expose batteries to sunshine or store/charge batteries at temperatures above 35°C or in a closed car. The high-temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging, or racing, do not charge it until it has cooled completely. Wait about 20 mins, then inspect prior to recharging.

Includes:

  • (1) ProTek LiHV 7.6V 2200mAh

Specifications

Nominal Voltage: 7.6V (2S)
Capacity: 2200mAh
Maximum Charge Rate: 1C (2.2A)
Discharge Rates
Continuous: 8C
Peak: (Not Available)
Cell Configuration: 2S2P
Watt Hours: 16.72Wh
ROAR Approved: No
Connectors
Battery: JR
Balance: XH
Dimensions (LxWxH): 3.35x1.18x0.67in (85x30x17mm)
Weight: 3.00oz (85g)

Battery Manual

Warranty Information

This product was added to our catalog on December 19, 2018

Edman Cheung
Verified Owner
Wednesday, Mar 23 2022 (about 2 years ago)
ProTek RC HV LiPo Receiver Battery Pack (Mugen/AE/8ight-X) (7.6V/2200mAh)
Just received this battery. It's DOA. One cell is at 3.78, other is at 0.67. This is new right out of the box and just checking the cells.

I'm going to return this unfortunately, I've lost my discount and free shipping for the next order. Hopefully Amain can accomodate.


--- Just an update, Amain has wonderful customer service and has corrected the issue. It's too bad the battery had an issue when it arrived, but it might be different for you.