ProTek RC 4mm Aluminum Long Clamping Servo Horn (Blue) (24T-Hitec)

Read Reviews
Write a Review
ProTek RC 4mm Aluminum Long Clamping Servo Horn (Blue) (24T-Hitec)
Back Order Now
You may back order this item and it will ship when it arrives.
$2.99 flat rate shipping! Learn More
Price: $11.99 (Save 58%)
Sale: $4.99

Please Log in to receive a notification when this item arrives in stock.

Save In List
This item earns up to 5 VIP Reward Points Learn More
This is a ProTek R/C 4mm Aluminum Long Clamp Lock Servo Horn, and is intended for use with any servo that uses a 24 tooth spline output shaft. This extremely tough servo-horn has been machined from a solid block of aluminum for incredible precision, rigidity and durability. This horn features a clamp type design that grips the servo’s output shaft with enough force that even if the retainer screw comes loose, the horn will remain in place, increasing your chances of finishing the race! Additionally, the arm is 4mm thick for durability, has 19.75mm & 24.25mm hole spacing and uses 3mm hardware to suit the geometry and hardware requirements of most vehicles.

Features:
  • Clamp design
  • 19.75mm & 24.25mm hole spacing (measured from output shaft screw hole, to linkage rod holes, center to center)
  • 4mm thick arm
  • 35.5mm Overall length
  • Linkage holes threaded for 3mm hardware
  • 24T Hitec Spline Output Shaft

This product was added to our catalog on March 8, 2012

Anonymous
Verified Owner
Monday, Apr 9 2012 (about 12 years ago)
ProTek RC 4mm Aluminum Long Clamping Servo Horn (Blue) (24T-Hitec)
I bought one of these to test on my XR10 (crawler). It works very well, though a bit longer than necessary for my setup.

But wanted to comment that this is very well-machined. It's definitely very beefy. I would imagine that to bend this horn, you'd have to hit it hard enough to destroy your servo, but I'm not going to test that. But all of it is machined perfectly. Slips right onto the HiTec servo without any strong effort and it bites exceedingly well once all three screws are tightened.

Amain won me over with their store brand quite a while back because every Pro-Tek branded item I've purchased has exceeded my expectations and has been superb quality in every regard.
Dirk Harvey
Verified Owner
Monday, Apr 4 2022 (about 2 years ago)
ProTek RC 4mm Aluminum Long Clamping Servo Horn (Blue) (24T-Hitec)
Terrible, cheap soft aluminum material. After a few months of use it has a ton of slop from the hole being oversized from wear.