Pro-Line Front Inboard Hub Kit (SC10)

Read Reviews
Write a Review
Pro-Line Front Inboard Hub Kit (SC10)
Price: $30.49
Discontinued Online
This item is discontinued and no longer available for purchase. You may want to search our site for a similar item.
Note: Manufacturer does not allow coupons
This is an optional Pro-Line Front Inboard Hub Kit, and is intended for use with the Associated SC10. This kit replaces the stock SC10 front hubs and axles, replacing them with a floating 12mm hex, so you can run Pro-Line’s ProTrac wheels in the front of your SC10. When combined with Pro-Line’s Rear Hex Adapters (PRO6064-05), you can run the same Pro-Trac Hex wheel on the front and rear of your truck! This kit is destined to become the must have item for the SC10 because it eliminates the need for front and rear specific wheels!

Features:
  • Direct replacement for your SC10 front hubs and axles
  • Allows 12mm Hex ProTrac offset wheels to be used on the front of your SC10 (PRO2727 Renegade, PRO2723 Split Six)
  • When used with PRO6064-05 Rear Hex Adapters, this kit allows for the same wheel to be used for the front and rear of your SC10
  • Race tested and approved by Ryan Cavalieri
What's Included:
  • (2) Molded steering knuckles
  • (4) Precision ball bearings
  • (2) Axles
  • (2) Shims
  • (2) Roll pins
  • (2) Axle nuts 

This product was added to our catalog on January 28, 2011

Michiel Huygelier
Verified Owner
Thursday, Feb 10 2011 (about 13 years ago)
Pro-Line Front Inboard Hub Kit (SC10)
Well tought out parts with a nice fit and finish.

thanks to Pro-line no need for front/rear specific wheels.
Lew Clayton
Monday, Feb 8 2021 (about 3 years ago)
Pro-Line Front Inboard Hub Kit (SC10)
The advice above to install all shim to the outside behind the hex is critical. I put these together before putting them in the caster blocks with 2 axle shims to the inside to remove slop. Pushing the kingpins through was difficult and really bound it up. Moved everything outside and ...perfect. I build instruction in the kit would have beneficial for that. Overall, outstanding quality as with everything from Pro-Line. Wish they were still making these for all us wanting to convert from RC10 to hex, they are perfect.
Anonymous
Saturday, Aug 13 2011 (about 12 years ago)
Pro-Line Front Inboard Hub Kit (SC10)
Good fit and finish. Parts seem high quality. One installation note, the shim goes on the hex side, not on the innermost side. If you put the shim on the shaft before putting it through the bearings, the pivot pin will interfere with the axle.

It will be nice buying a single wheel/tire format for my SC10 and SC10 4x4 now!