Precision RC Works Dragon 3 Position Winch Controller

The Precision RC Works Dragon 3 Position Winch Controller is a "no creep" relay type winch controller that will put a little fire behind in your winch! These are sealed and coated with liquid electrical tape for extreme water resistance, and the controller features a 5 amp relay rated for up to 30 volts of direct battery input. The chip that controls the relay can handle a max 6 volt input from the receiver, so this will require an additional inline voltage regulator if you run high voltage to your receiver or BEC. 

Features:

• No creep relay winch controller
• Operates from open channel on your receiver
• Utilize a 5 amp relay rated for up to 30 volts direct battery input
• Will not creep, on or off
• Female JST plug for connecting to the winch
• Battery side is male JST plug and includes a female pigtail to solder on to your battery of choice OR use to make a pass through type connector
• These are sealed and coated with liquid electrical tape for extreme water resistance
• Backed by a manufacturers limited lifetime warranty against defects! Contact Precision RC Works for an RMA to send in for repair or replacement.

NOTE:

• Precision RC Works has received reports of glitching when used with a Savox servo. This glitching goes away if you use a voltage regulator. Some servos pull too many amps for proper operation without a voltage regulator.
• WARNING: The Dragon controller has no power limits and can destroy your winch if not used properly. Follow all setup procedures and instructions in the package, and use with caution. Check your winch specs before use. Precision RC Works/A Main Hobbies are not responsible for damaged winch motors.