OFNA CNC Machined Aluminum Double Arm Servo Horn (25T-Futaba/Orion/Savox/ACE)

This item is discontinued and no longer available for purchase. You may want to search our site for a similar item.
Low Price: $11.99
Discontinued Online
This is an OFNA CNC Machined Aluminum Double Arm Servo Horn, and is intended for use with servos that have a 25T spline output shaft. This servo horn has been CNC machined from high grade aluminum for precision and durability, and features a clamp type holding mechanism. This allows the servo horn to grip the output shaft, so if the output shaft screw vibrates loose, the servo horn will remain attached to the servo allowing you to remain in control of your model! Additionally, the linkage holes are 3mm, for versatility and universal compatibility with almost any vehicle.

This product was added to our catalog on March 17, 2011.

Robert Pomroy
Verified Owner
Tuesday, Aug 18 2015 (about 2 years ago)
OFNA CNC Machined Aluminum Double Arm Servo Horn (25T-Futaba/Orion/Savox/ACE)
Very good servo horn, I have on my XB8-15 and its taken some serious driving.
One thing that would be good if they could leave a selection of holes not threaded.
There are three holes each side one end with the centre hole thread-less and the other end with the inner and outer holes thread-less, this would facilitate mounting the throttle/brake linkage easier.
All in all a very good product worthy of five stars by a long measure.)