Muchmore Light Weight 1/8 Scale Setup Board 3 (400x500mm)
The Muchmore Light Weight 1/8 Scale Setup Board 3 is made from 12.6mm thick hardwood and measures 500x400mm.
Features:
- Light weight setup board
- Made with Hard-wood
- Thin thickness reduces weight
- Board is covered in hard plastic and can be easily cleaned
- Measures 500x400x12.6mm
- Weighs 145g
This product was added to our catalog on April 5, 2017
Sebastian Ganly
Verified Owner
Wednesday, Jul 1 2020 (about 3 years ago)
Muchmore Light Weight 1/8 Scale Setup Board 3 (400x500mm)
Good board, light weight as well. This is not an issue with the board, but if you have the ProTek hauler bag, it is a very tight fit.
Zario Collie
Verified Owner
Sunday, Jun 28 2020 (about 3 years ago)
Muchmore Light Weight 1/8 Scale Setup Board 3 (400x500mm)
I was torn between this board and a similar version from Hudy. Needless to say, I purchased this one for two reasons, overall weight and price. I run a 1/10 Yokomo YD2 drifter so it's more than enough space for my needs. I do recommend pairing it with a pit mat/yoga mat for added stability. I found with my YD2 centered on the board, it has a tendency to move around a little during setup. The addition of the yoga mat solved this issue plus it limited runaway screws and spacers.
not me
Verified Owner
Wednesday, Dec 13 2023 (4 months ago)
Muchmore Light Weight 1/8 Scale Setup Board 3 (400x500mm)
this board is NOT flat. if i check camber with a camber guage (not setup station) the camber differs by 1-2 degrees depending on which side of the board you use. the measurements were extremely consistent as i checked chamber many, many times just to make sure. one side of the board is like ) while the other side is shaped like (. this is also very obvious when you use a strait edge on each side. every thing i notice about the warp in the board agrees with each other.
also, the surface of the board is texured. not sure how that can possibly make for a good setupboard when a setup station has to slide across it (when checking camber or toe as you compress the suspension to get it to settle to ride height. 2 stars is generous.
also, the surface of the board is texured. not sure how that can possibly make for a good setupboard when a setup station has to slide across it (when checking camber or toe as you compress the suspension to get it to settle to ride height. 2 stars is generous.
