MIP "Pucks" TLR TEN-SCTE 2.0 Center Drive System Pro4mance Pack
MIP13120
This item is discontinued and no longer available for purchase. You may want to search our site for a similar item.
Note: Manufacturer does not allow coupons
This is the optional MIP "Pucks" TLR TEN-SCTE 2.0 Center Drive System Pro4mance Pack . MIP Pucks™ Center Drive System for the TLR SCTE 2.0 is a low rotating mass center drive system made from 7075-T6 Aluminum. This drive system removes half the weight out of the center drivetrain, resulting in higher acceleration and deceleration. The MIP Pucks™ Drive System is like a 10th degree ninja master - whisper quiet with no backlash!
COMPETITIVE ADVANTAGES:
The MIP Pucks™ Drive System, Center, TLR SCTE 2.0, MIP Pro4mance™ Pack is for RC racers who need the competitive advantage of increased speed and acceleration, with quicker deceleration.
Features:
- Removes half of the weight out of the center drive system
- Whisper quiet drive system
- Tight fit with no back lash
- Higher acceleration & deceleration rates
- Made from hard anodized 7075-T6 Aluminum
- Laser badged
- 100% quality made in the USA!
Includes:
- (2) MIP Center Diff Aluminum Outdrive Losi Ten-SCTE
- (1) MIP Aluminum Lite C-CVD™ Bone Long Losi Ten-SCTE
- (1) MIP Aluminum Lite C-CVD™ Bone Short Losi Ten-SCTE
- (2) MIP Center Input Hub Losi Ten-SCTE
- (6) HW-BHCS 1-72 x 1/8
- (8) MIP Keyed Drive Puck Ten-SCTE
- (2) MIP Keyed Drive Pin C-Drive Ten-SCTE
- (2) MIP Capture Rings C-CVD™
- (2) MIP 3/16” CVD™ Coupling
- (2) HW-Pin 1/16 x .430 Solid Pin
- (2) HW-SHSS 4-40 x 3/32 Cup Point
- (2) HW-SHSS 8-32 x 1/8 Cup Point
- (1) MIP Lube & Thread Gel Cup
- (2) MIP Confetti Sticker
This product was added to our catalog on October 30, 2013
Anonymous
Verified Owner
Friday, Jul 4 2014 (about 9 years ago)
MIP "Pucks" TLR TEN-SCTE 2.0 Center Drive System Pro4mance Pack
If you are looking to upgrade your center driveshafts on your scte, go check out the ones Tekno makes. I probably have around 10 hours on these drive shafts, and I have replaced the pucks once. My pucks didnt seem to be wearing either but my out drives were. They just wore enough that the set screws holding the puck on, wore the center out drives. Now the out drives are sharp, you can go through pucks in an hour. I wouldn't reccomend these to anyone. My friend and I both had the same problem. Go get a set of tekno driveshafts instead.
Eric Marrison
Verified Owner
Saturday, May 17 2014 (about 9 years ago)
MIP "Pucks" TLR TEN-SCTE 2.0 Center Drive System Pro4mance Pack
Can't speak for reliability as I've only run about 5 packs through these so far. They show no signs of wear so far, which I was worried about considering the power is transferred through the orange pucks (made of some type of heavy duty plastic). They are better centered/balanced than the stock driveshafts. The stock ones were visibly wobbly, these look great. The outdrives from the center differential are lighter and they have oil grooves. After my stock driveshafts wore out from hard braking I upgraded to these and am very happy so far. You may want to purchase a few extra sets of orange pucks since it is recommended that they're replaced every 30 runs.