M2C Tekno MT410 "Go Big" Rear Tower/ Chassis Stiffiner Kit

The M2C Tekno MT410 "Go Big" Rear Tower/Chassis Stiffener Kit was designed to fit the MT410 and is machined from 7075 aluminum and anodized black. These parts are made for the basher in all of us. These parts are designed to be super tough and everything is tied together for additional strength. This system should withstand about anything you can throw at it. But keep in mind 1 thing, anything can be broken in the RC industry.

The heart of this system is the V3 tower support block. This has beefed it up so it is not going anywhere. The shock tower support plate keys into the v3 tower support plate at the bottom. the tower ears are 4.3mm thick. With the additional 4.5mm of the original towers this will give you an 8.8mm thick shock tower. The tower will also have 2 additional 3mm x 16mm screws to anchor the 2 towers together. These holes will be drilled by hand by you after you assemble the parts.

The body post support block is sandwiched between the 2 towers for additional strength of the body post. The tower ears are tied together with the included shock cap support post that has a 4mm retainer nut to hold shock cap on. The Horizontal brace is bolted to the rear tower support and bolted to the motor mounts to give you a solid locked system all the way through the chassis. M2C also added an ESC mount plate that will bolt to the top of the horizontal brace or to the rear radio tray, giving you some mount options for the ESC.

This kit does not include the center brace (M2C6905) as many already have this part.

NOTE:

• Since most of these trucks have already been ran, it is possible that some parts may be tweaked a bit.
• When assembling parts leave all parts loose until all screws are started.
• See Assembly Video Below 

This product was added to our catalog on December 14, 2018