M2C 4mm Tekno Threaded Hinge Pin (4)
M2C6725B
This item is discontinued and no longer available for purchase. You may want to search our site for a similar item.
This is a pack of four Tekno 4mm Tekno Threaded Hinge Pins, with an included .166 drill bit and locknuts. These pins are made using 01 tool steel and are nickel coated. These pin is designed to add more support over the stock pins.
You will use the provided .166 bit to drill thru the stock bushing allowing the hinge pin to extend out of the bushing. With this, dab a little loctite on the hinge pin threads, and attach the included lock nuts. This will allow you to remove the front or rear block for maintenance without removing the bulkhead.
Due to the extreme conditions these pins are subject to, M2C does not provide any warranty against breakage or bending.
These hinge pins are approximately 73mm long, from end to end. They are 66mm long not including the threads.
NOTE: These pins will work on all models, but, if you use them on the sct, you will have have to drill a hole in the rear of the radio box as there is no clearance for the 4mm nut, so be aware of this.
This product was added to our catalog on September 26, 2016