The M2C Hot Bodies D815 8x16 Bearing Rear Upright is machined from 6061-t6 aluminum and uses an 8x16x5mm inner hub bearing, instead of the less common 12x21x5mm bearing. The hub is made to the same specs as the stock part, but the lower bushing support arms have been squared off for additional support. Package includes an 8mm nut and bolt to assist in assembly as the bearing fit is very close tolorence and needs to be perfectly aligned during assembly.
- This hub must be combined with the Mugen 90mm long universal drive shaft (MUGE2218), and is compatible with the stock 17mm hex hubs.
- During setup, You need to make sure that you have clearance for the universal at the hub side of the driver shaft. At full droop (130mm) it could hit the arm. If necessary you may need to dremel the arm in this area. M2C did not see any issues from 124mm to 128mm droop.
This product was added to our catalog on April 20, 2016.