Lynx Heli Blade 130 X DS-883-HV Tail Servo

Lynx Heli
This item is discontinued and no longer available for purchase. You may want to search our site for a similar item.
Low Price: $22.09
Discontinued Online
This is the Lynx Heli Blade 130 X DS-883-HV Tail Servo. Lynx now offers a dedicated High Voltage tail servo for your 130 X! The Lynx DS-883-HV servo was designed to work with a standard FBL system or with a 3-in-1 motherboard when an external BEC is used. The HV edition servo must be powered by an external BEC with a minimum 4.8 to maximum 6.5 Volts. For performance and security reasons, Lynx does not recommend that you power the HV servo with the stock 3-in-1 integrated BEC. The servo will not work properly and will damage the 3in1 mother board.

  • Type: Metal Gear Digital Precision Servo
  • Input (V-in): 4.8 to 6.5 V
  • Frequency: 450 Hz
  • Neutral Point: 1500μs
  • Speed:
    • @ 4.8V: 0.07 sec / 60
    • @ 6.5V: 0.06 sec / 60
  • Stall Torque:
    • @ 4.8V: 17.36 oz in (1.25 kg cm)
    • @ 6.5V: 22.21 oz in (1.60 kg cm)
  • Dimension: 19.60x8.00x19.40mm
  • Weight (including 160mm cable connector): 5.25g
  • Output Gear support: Radial bearing 4x7 W2
  • Servo Arms: 4 type included (see pictures)
  • Servo Case Material: Technopolymer base plastic Clear Blue Color

  • (1) Digital Precision MG rotative tail servo DS-883-HV, with necessary servo arms and hardware.
  • (1) JR to 3in1 mother board adaptor (Use the HV servo with your 3in1 with external BEC power supplier)

  • The HV edition must be powered by an external BEC with minimum 4.8V to maximum 6.5V.
  • For performance a security reason Lynx recommends that you DO NOT power the HV servo with standard 3-in-1 integrated BEC. Servo will not work properly and will damage the 3-in-1 mother board.
  • Lynx testing has shown that the best servo arm length is between 5.5 to 6.5mm.
  • Start with 6.5mm and set the servo travel the same as the linear servo, do not increase that travel.
  • Start with -5  Tail Gyro setting and test your Heli tail.
  • During your test, adjust the tail gain to suit your needs and Heli setting. If with all full negative Tail Gyro setting you still have tail wag, adjust the servo arm length to 6 or 5.5mm and restart the test.
  • Unfortunately is almost impossible for Lynx to provide the best standard value because there are too many factors that can influence the gain setting.

This product was added to our catalog on January 15, 2014.