Exclusive RC Traxxas UDR Rear Light Bar
ERC10-TRA-8004
This item is discontinued and no longer available for purchase. You may want to search our site for a similar item.
The Exclusive RC Traxxas UDR Rear Light Bar is a 3D printed option that will allow you to add the details your UDR deserves. The light bar is pre-wired and ready for installation, and looks exactly like the light bar on the full size Rigid Industries race truck! Plus, it can be powered directly off the receiver, making it super easy to take your scale details to the next level.
The parts are easy to install. Simply follow the instructions below. This is printed in carbon nylon filament. Carbon nylon creates stronger parts with finer detail than PLA filament. Plus, carbon nylon sands better and is easier to paint, so you can add more details if you choose.
NOTE: With most 3D printed items, some light finish work may be needed to remove excess material. Simply use a sharp hobby knife to carefully remove small strings and straggler layer lines as needed.
Installation Instructions:
- Remove body
- Remove interior panel
- Remove receiver lid
- Remove radiator
- Install rear light bar bracket
- Plug up light bar to open slot on receiver with a servo plug (not included)
- Cover receiver
- Install interior
- Install brackets for Radiator small holes for radiator, big holes for chassis (do not install radiator yet)
- Install body while light bar is still loose and hanging by the wires so its easier to shift up and get to the screws
- Screw light bar in from the bottom with supplied screws
- Install Radiator with new brackets to lower radiator
- Turn it on and RUN IT!
This product was added to our catalog on June 28, 2018