Exclusive RC HPI Venture Rear Wiper & Antenna Mount (Carbon Nylon)
The Exclusive RC HPI Venture Rear Wiper & Antenna Mount are 3D printed replica parts that will allow you to ditch the factory decals and add the detail your Venture FJ deserves.
The wiper is easy to install using the factory decals as your templates. Drill an M2 hole and use your hardware to secure the wiper into position. Choose the location where you want to install the antenna mount, and drill an M2 hole for installation. Use hot glue, shoe goo or E-6000 adhesive as a secondary measure to secure the parts to the body.
This is printed in carbon nylon filament. Carbon nylon creates stronger parts with finer detail than PLA filament. Plus, carbon nylon sands better and is easier to paint, so you can add more details if you choose.
NOTE: With most 3D printed items, some light finish work may be needed to remove excess material. Simply use a sharp hobby knife to carefully remove small strings and straggler layer lines as needed.
This product was added to our catalog on March 20, 2018.