Dynamite Fuze 70A Waterproof Brushless ESC

This is the Dynamite Fuze 70A Waterproof Brushless ESC. The Fuze 70A ESC is waterproof, completely programmable and comes pre-wired with a high-current EC3 connector. The 70A design makes the ESC extremely robust and will handle extreme power demands from today's sensorless brushless motors. The ESC will work with most sensorless brushless motors and is 3S Li-Po and Ni-MH compatible. The ESC was designed specifically to work with most on- and off-road 1/10-scale applications.

Features:

• Waterproof*
• Compatible with 4-9 cell NiMH/NiCd, or 2-3Cell LiPo/LiFe
• Compatible with most sensorless motors
• High power, built in BEC system for stable receiver and servo power supply
• ESC settings include forward/brake with reverse or forward/brake for racing
• Low voltage cutoff protection in ESC protects batteries from over-discharge
• Cooling fan included
  

Specifications:
Auto Cutoff: Yes
Brake: Yes
Reverse: Yes
Forward: Yes
Time Delay Brake: Yes
Input Connector Type: EC3
Output Connector Type: 3.5mm Bullet
Maximum Burst Current: 290A
Maximum Continuous Current: 70A
Motor Limit: 2S LiPo - up to 6000KV . 3S LiPo - up to 4000KV
Speed Control Type: Brushless - Sensorless
BEC Type: 6.0V
Full on Resistance: .0012 ohm
Wire Gauge: 14AWG

*NOTE: This ESC is waterproofed for use in wet conditions. Make sure the other components in your vehicle are waterproof or water resistant before driving in wet conditions.

This product was added to our catalog on February 24, 2014