Reviews for Dynamite Black Universal CVA Shaft Boots (Tmaxx, MBX5, TTR) (4) [DYN7687]

Displaying reviews 1 to 4 of 4
Result Pages: 1
Bill Carlson
Verified Owner
Sunday, Apr 10 2011 (about 5 years ago)
Dynamite Black Universal CVA Shaft Boots (Tmaxx, MBX5, TTR) (4)
Rubber is a little too thin, don't stay on my HB DB rear shafts even with fuel tubing on the shaft.
paul smith
Verified Owner
Sunday, Jun 10 2007 (about 9 years ago)
Dynamite Black Universal CVA Shaft Boots (Tmaxx, MBX5, TTR) (4)
Don't use these on the MBXT outer CV joints they will not fit properly on the front, and quickly wear out and start to holding dirt. The only place they work out well is on the inner drive shafts.
Rob Ralston
Verified Owner
Wednesday, Feb 1 2006 (about 10 years ago)
Dynamite Black Universal CVA Shaft Boots (Tmaxx, MBX5, TTR) (4)
These also fit the TTR S3. Clean up your CVA with some fine sandpaper then clean it and the Boot with some solvent and blow dry and then glue together. I normally then inject a small amount of grease into the CVA for smooth action.
Jomari Cura
Verified Owner
Sunday, Apr 6 2008 (about 8 years ago)
Dynamite Black Universal CVA Shaft Boots (Tmaxx, MBX5, TTR) (4)
do not buy this boot.they are a waste of time and money.they come off easily after 1 race heat.if u want a boot that holds get a RC BEST boots...thats what i used and they never come off.....