CBE RC Fab Switchblade Steel Chassis Rail Set

Low Price: $37.99
Add To Cart Add to Wish List
Usually ships in 24 hours
$1.99 Flat Rate Shipping!
This item is eligible for $1.99 flat rate shipping Learn More
This item earns up to 38 VIP Reward Points Learn More

The CBE RC Fab Switchblade Steel Chassis Rail Set is the ultimate high performance chassis for class 1 trucks with an 11" - 12" wheelbase. The Switchblade chassis rails are identical to the Switchback rails from the front to center. The rear is where the changes take place. The flat rear half of the chassis provides the clearance needed to run a drop bed, and also allows the use of a cantilever rear shock setup. The design should work great with leaf spring setups and standard rear shock hoops as well!

With the ability to adapt almost any skid, these rails fit the Axial SCX10/SCX10 II and Wraith, the GMade Sawback, and the Vaterra Ascender platforms! The Switchblade offers 12 upper link mounts for the front and rear, and three mounting points for the shock towers, as well as forward, center or rear positions for the SCX10 skid! Plus, by drilling one hole in the rail and using the pan hard mount from the SCX10 II, the rails are fully compatible with the SCX10 II battery tray and CMS system. Made in the USA, ready to install and cut from cold rolled steel - if you have been looking to build a high performance class 1 truck, the Switchblade is the perfect weapon.


  • Builders chassis for 11 to 12" wheelbase
  • Flat rear provides clearance to run a drop bed or a cantilever rear shock setup
  • High clearance front over stock
  • 3 positions for front shock tower placement
  • 3 positions for SCX10 skid - centered, forward, rearward
  • Fits Wraith skid centered
  • Fits GMade Sawback and Vaterra Ascender
  • 12 upper link tuning positions for the front and rear
  • 12 gauge raw unfinished steel
  • Combine with CBE Shock Gear towers (CBESHKGR) for unmatched shock tuning possibilities

This product was added to our catalog on September 18, 2017.