Castle Creations Multi Rotor 35 Expansion Pack 35-Amp ESC (No BEC)
This is the Castle Creations Multi Rotor 35 Expansion Pack 35-Amp ESC with no BEC. Got more than four rotors? Pick up a few single Multi-Rotor ESC's and finish your project without buying any gear you don't need! This ESC does not have a BEC and has optimized firmware specifically designed for quadcopter and other multi-rotor platforms. Refresh rates up to 490 Hz give your platform optimum stability and maneuverability without missing a beat. The ESC comes pre-programmed for multi-rotor platforms and is recommended for platforms ranging from 450 to 650 sizes pulling up to 35 amps** and running up to 6S LiPo. As with all Castle ESCs, this product is easily programmable using the Castle Link USB adapter (sold separately).
Continuous Maximum Current: 35A
Input Voltage: 7.4-22.2V (2-6S LiPo)
Input Connector Types: Bare Wire
Output Connector Types: Bare Wire
Length: 1.93 in (49mm)
Width: 0.88 in (22.4mm)
Height: 0.33 in (8.4mm)
Weight: 0.98 oz (27.8 g) each
BEC Voltage: N/A
**NOTE: RC HOBBY APPLICATION RATING: 35 amps for the duration of a single 4,000 mAh battery pack with the ESC's in contact with a 5 mph airflow of 25C (77F) or cooler air. Controller temperature must never exceed 100C (212F). Exceeding current or temperature ratings may damage components and may shorten the life of the ESC. Always verify system current draw at full-throttle. Decrease load or increase airflow to decrease the ESCís operating temperature.
This product was added to our catalog on April 15, 2014.