Align 6S1P Li-Poly Battery 40C (22.2V/3300mAh)
This is a Align 6S2P Li-Polymer Battery, and is intended for use with the Align T-Rex 500 and 600 class electric helicopters.
- This Li-poly battery is built using a series/balancing design. It features high efficiency and high discharge, and an inspection machine is used to match the packs.
- Suitable for TREX 500 & 600
- Recommend to discharge the battery within 80% of rated discharge, keep 90% capacity when over 100 cycles, keep 85% capacity when over 150 cycles. (The cycle life and efficiency will reduce due to high current, high temperature and over-discharge)
Nominal Voltage: 22.2V
Capacity: 3300mAh (57Wh)
Max Continuous Discharge: 40C
Burst Discharge: 50C
Max. temperature: 80°C
NOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in over heated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not use the battery that has too low a voltage.
Do not expose batteries to sunshine or store/charge batteries at the temperature above 35°C or in a closed car. The high temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging or racing, do not charge the battery until it has cooled completely. Wait about 20 mins, then inspect prior to recharging.
This product was added to our catalog on June 22, 2011.