Align 1S1P LiPo Battery 20C (2) (3.7V/530mAh)
AGNHBP05301
This item is discontinued and no longer available for purchase. You may want to search our site for a similar item.
This is a pack of two replacement Align 1S1P, 20C, 3.7V, 530mAh Li-Poly Battery Packs. These battery packs are used in the Align M424 Micro Electric Quadcopter.
Specifications:
Type: Lithium Polymer
Capacity: 530mAh
Voltage: 3.7V nominal
Number of Cells: 1
Weight: 15 grams
Configuration: 1S1P
Dimensions: 46.3x26.8x8.7mm
Maximum Continuous Discharge: 20C
IMPORTANT:
1) You will need a Li-Poly specific charger to charge the pack (NiMH or NiCD only chargers WILL NOT WORK!)
2) You must not over discharge the Li-Poly battery pack.
3) Read the instructions carefully before operating this battery.
NOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in over heated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not use the battery that has too low a voltage.
Do not expose batteries to sunshine or store/charge batteries at the temperature above 35°C or in a closed car. The high temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging or racing, do not charge the battery until it has cooled completely. Wait about 20 mins, then inspect prior to recharging.
This product was added to our catalog on February 14, 2014