1UP Racing WellCut 1/8 Front Body Post Marker Tool (7mm)

The 1UP Racing WellCut 1/8 Front Body Post Marker Tool is a must have in any 1/8 nitro racer’s tool box. These fit 7mm diameter front posts. 7mm primarily fits Serpent front posts, but may fit others as well.

Steps:

• Place the WellCuts over the front body posts with the magnets facing the rear of the car and secure them with 2 body clips.
• After using the WellCut Template to cut out the rear of the car, set the body on the car and drop the front 2 outer magnets into place. The super strong magnets will immediately center themselves!
• Use a fine tip black permanent marker to mark the center hole.
• Remove the body and cut the 2 holes with a body reamer and you’re set!