1UP Racing On-Road Elevate Car Stand
1UP160205
This item is discontinued and no longer available for purchase. You may want to search our site for a similar item.
The 1UP Racing On-Road Elevate Car Stand pairs the extremely durable 1up Racing Pro Car Stand with beautiful Carbon Fiber. Whether you’re applying tire additive or getting into full wrench mode, the elongated stand provides a stable base for easy maintenance of electric sedans, nitro sedans, pan cars and 1/8 nitro cars.
Designed and assembled in California. Each Elevate Series Pro Car Stand is assembled by hand at 1UP headquarters in Orange County, CA. Attention to detail is top priority and 1UP will only deliver a perfectly finished product you’ll be proud to show off. Pro Car Stands are molded from extremely dense and durable foam material designed to hold up to years of abuse. Now found in hundreds of pits around the world, these are tested and proven to be resistant to spilled tire additive and nitro fuel.*
Specifications:
Dimensions: 90mm x 210 x 25mm
Top Surface: 80mm x 200mm
*NOTE: Extremely harsh chemicals will dull the surface, wipe away immediately if spilled!
This product was added to our catalog on October 7, 2020
Michael Turkington
Verified Owner
Wednesday, Jun 23 2021 (about 2 years ago)
1UP Racing On-Road Elevate Car Stand
Ok it’s pretty yes but I think it leaves a lot missing in function for $31 I’m disappointed.
First the foam is so hard it slides on the table or set up board even on a 1up pit mat is slides all around.
Next When you put the car on it the car slides all around it needs to be sticky so the car stays on it.
Just put some rubber feet on it right ? Good luck getting anything to stick to it. The fact that it is resistant to tire compound and fuel is good but sure would be more useful if the car stayed put when your trying to put tire compound on !! Sorry1up guys I like lots of your stuff but this is off the mark as far as I can tell. I have to cover it with a micro fiber towel to use it and I wish it was longer to support under both diffs when wrenching on car (X-ray t4 21).
First the foam is so hard it slides on the table or set up board even on a 1up pit mat is slides all around.
Next When you put the car on it the car slides all around it needs to be sticky so the car stays on it.
Just put some rubber feet on it right ? Good luck getting anything to stick to it. The fact that it is resistant to tire compound and fuel is good but sure would be more useful if the car stayed put when your trying to put tire compound on !! Sorry1up guys I like lots of your stuff but this is off the mark as far as I can tell. I have to cover it with a micro fiber towel to use it and I wish it was longer to support under both diffs when wrenching on car (X-ray t4 21).