| Displaying 21 to 40 (of 6138 reviews) |
Result Pages: 2 |
|
 |
|
|
 |
I bought these because I decided to ditch the rubber boots (they always tore and seemed to get in the way). These protect the shock shaft. Very well made, work great.
Rating:  |
|
|
|
|
|
|
 |
would these fit on the slash with the proline protrac suspention kit?
Rating:  |
|
|
|
|
|
|
 |
Very nice, very precise. Apply very light pressure not to damage the foam inside.
Rating:  Verified Owner |
|
|
|
|
|
|
 |
Good product. Cap screws tightly. Needle cap is tight too. Squeezing hardness is like medium.
Rating: Verified Owner |
|
|
|
|
|
|
 |
These motors were great. Recently I bought 2 of these and received D3 motors instead. Not impressed. Do not buy if you want D2 motors.
Rating: Verified Owner |
|
|
|
|
|
|
 |
Vince I think your 100% correct on everything you stated.
Get the aluminum skids, aluminum hb servo horn, vorza foam servo saver setup, trim your motor shaft so it's not close to the battery, make a shield between pinion and battery, and some are […]
Rating: |
|
|
|
|
|
|
 |
This bumper works for "bumping" into other cars. But if you nose down off a jump to many times you will break the bumper. I am on my third one. I broke my first bumper on concrete in my shop off a jump. The second I broke from getting hit in mid air […]
Rating: |
|
|
|
|
|
|
 |
I ran this on my losi 8ight b rtr and it did extremely well. It was 100 times better than stock and I had no problems having it center after a turn, I actually had trouble controlling it because of its response time. I have truly enjoyed the servo […]
Rating: |
|
|
|
|
|
|
 |
Easy body to cut out! Great quality lexan and premarked holes for body post with easy instructions. Very detailed instructions for mounting and even some notes on decal page. No body rub on fenders.
Rating: Verified Owner |
|
|
|
|
|
|
 |
The Rc8.2e is a great improvement over the rc8be. It handles much better over the rough stuff and is more forgiving.
Rating: |
|
|
|
|
|
|
 |
Got it today and couldn't wait to try it out. Didn't even have to bind it. Must've been done already at the factory.
Man, when you go from cheap AM radios to 2.4ghz *whistles
My truck (E-Firestorm w/5700kv 2s) is really fast and I had to be careful[…]
Rating: Verified Owner |
|
|
|
|
|
|
 |
These will fit the XR10 shocks just fine, but depending on your setup, the fact that they're square/flat across the entire top can cause them to bind against the shock mounting nut. I was able to put a thin 3mm nylock nut on it instead of the regula[…]
Rating: Verified Owner |
|
|
|
|
|
|
 |
I hated the design where the rear body mounts are. It is recessed down so the clips are a pain to get in
Rating: |
|
|
|
|
|
|
 |
Good product from JS Models, has 10mm hole. This swash plate is for 120 degrees eccpm but you can purchase Part no. JSS - 1634 Long Linkage Ball for 140 degrees eccpm system for more precise control.
Rating: |
|
|
|
|
|
|
 |
High quality clutch bell, light weight and has two holes on top for installing governor magnets...!!
Rating: |
|
|
|
|
|
|
 |
I have been running this wing for a while now with no issues. I have landed upside-down and everything super durable.
Rating: Verified Owner |
|
|
|
|
|
|
 |
Awesome buggy! Looks is a 10/10! Tracking it for 2weeks now! Up to now no repairs has done! For all beginners, this a great way to start! Make sure do the new setup guide protocol and you are set for bashing, jumps, and etc!
Rating: Verified Owner |
|
|
|
|
|
|
 |
this trucks power and handling well pasted my exspectations, I was nervious about this purchase at first never have had owned 1/5 scale truck, and had been running the sc8e,hpi blitz,and traxxis slayer. this truck does all the jumps with the same eas[…]
Rating:  Verified Owner |
|
|
|
|
|
|
 |
Great Product, Keeps everything clean and dry. Money well spent
Rating: |
|
|
|
|
|
|
 |
9mm Venturi POWERR!!! / 7mm Venturi Balance / 5.5mm Venturi Stupid Mileage :)
Rating: Verified Owner |
|
|
|
|
| Displaying 21 to 40 (of 6138 reviews) |
Result Pages: 2 |
|
|
