Spektrum RC S9020 1/5 Scale Digital Metal Gear Surface Servo (High Voltage)
This is the Spektrum S9020 1/5 Scale Digital Metal Gear Surface Servo. No servo on the market has been able to fully live up to the expectations of today’s 1/5-scale community or the performance demands of vehicles like the Losi 5IVE-T. Servo fade, weak holding power and the crowbar effect are just a few of the issues found with even the most expensive large scale surface servos! The Spektrum S9020 servo completely changes how 1/5-scale vehicles perform.
The S9020 starts with patent-pending Back EMF technology, drivers no longer have to be concerned with servo fade after just a few minutes of run time and inferior holding power. The S9020 HV servo maintains optimum performance levels throughout the entire run while providing speed and torque ratings that put it in the ranks of servos that cost twice as much.
Dynamic breaking technology assures the vehicle maintains the heading demanded thanks to the servos brute level of holding power. An improved integrator design virtually eliminates the crowbar effect while keeping the servo temps low through even the most grueling of runs. Using Back EMF technology, position lock exponentially improves the servos ability to keep its position while greatly increasing holding power. In addition, the S9020 offers virtually zero servo fade, no matter how much is thrown at them. Forget about doubling up on expensive and heavy dual servo mounts. The S9020 won’t fade under any condition.
- Improved integrator design eliminates crowbar effect and reduces heat build-up
- Socket-head cap screws
- HV for use with 2-cell Li-Po’s
- Recommended for Steering applications
- Spektrum S9010 recommended for throttle applications
- Removable, hi-strength servo lead
- Low profile standard 1/5-scale size
- Hardened steel gears
Bushing or Bearing: Bearing
Connector Type: Z-Connector
Connector Wire Gauge: 22 AWG
Connector Wire Length: 7.87 in (200mm)
Digital or Analog: Digital
Gear Material: Steel
Gear Type: Metal
Height: 1.80 in (45.50mm)
Input Voltage: 6.0-8.4V
Length: 3.00 in (75mm)
Rotation Range: 120
Servo Type: Digital
Size Category: Custom
Specific Application: 1/5 Scale
Spline Count: 15 teeth
Weight: 5.0 oz (142g)
Width: 1.20 in (30mm)
This product was added to our catalog on January 31, 2014.