XRAY Hudy Spring Steel Equalized Cornering Speed (ECS) Driveshaft (50mm)
XRA305325
This item is discontinued and no longer available for purchase. You may want to search our site for a similar item.
This is a optional XRAY 50mm Equalized Cornering Speed (ECS) Drive Shaft. This ECS drive shaft was designed with high-level racing in mind. The ECS drive shafts were developed to decrease front wheel vibration when racing with a solid front axle, thus providing a much smoother and quieter ride and increasing steering.
The ECS drive shaft equalizes the speed between the drive shaft and the wheel. With a unique 2-piece joint between the axle and the wheel, the same extreme wheel turning angle is divided into two shallower angles without joint binding. This means that at the same cornering speed, the inner wheel will not bind or vibrate. Drive through the corner is more stable, more precise and easier to drive.
With the new ECS drive shafts, wheel vibrations and noise are decreased to minimum, steering is increased and cornering speed and smoothness increases noticeable.
The ECS drive shaft comes factory pre-assembled for quality checking, but it is not immediately ready to use. Before using follow the instruction manual.
NOTE: To use the ECS drive shafts you need to use the front C-hubs V2 with the larger opening. The C-hubs V2 were included in all T2'008 kits, so owners of the T2, T2'007 and T2R must purchase the C-hubs V2 separately.
The ECS drive shaft equalizes the speed between the drive shaft and the wheel. With a unique 2-piece joint between the axle and the wheel, the same extreme wheel turning angle is divided into two shallower angles without joint binding. This means that at the same cornering speed, the inner wheel will not bind or vibrate. Drive through the corner is more stable, more precise and easier to drive.
With the new ECS drive shafts, wheel vibrations and noise are decreased to minimum, steering is increased and cornering speed and smoothness increases noticeable.
The ECS drive shaft comes factory pre-assembled for quality checking, but it is not immediately ready to use. Before using follow the instruction manual.
NOTE: To use the ECS drive shafts you need to use the front C-hubs V2 with the larger opening. The C-hubs V2 were included in all T2'008 kits, so owners of the T2, T2'007 and T2R must purchase the C-hubs V2 separately.
This product was added to our catalog on February 20, 2009