|
This is the ProTek R/C 2S, 35C 5200mAh Lithium Polymer saddle battery
pack with a hard case - perfect for saddle packs in 1/10th scale vehicles! These
packs have ultra T-style connectors attached,
and
comes with a 4-pin Align/E-Flite style balance connector. These
packs are ideal for use as saddle packs in electric RC cars.
These battery packs are built using a hard plastic pack that is
required for use at ROAR sanctioned tracks and events.
For
mounting in a saddle pack configuration for cars like the Associated
B44, we recommend you mount the battery flat to the chassis and use
some kind of velcro or servo tape to secure them to the upper battery
strap. This will stop the batteries from sliding out of the car
sideways. To mount them flat you may need to remove the plastic battery
holder from the chassis. If you have a strap permanently attached to
the top of each battery, you can easily remove them from the vehicle
for charging and simply put another battery in its place.
Specifications:
- Type: Lithium Polymer
- Capacity: 5200 mAh
- Voltage: 7.4V nominal
- Connector Type: Utra T-Style
- Balancer Type: Align/E-Flite compatible (XH)
- Number of Cells: 2
- Weight: 321g (7.07oz)
- Configuration: 2S3P (wired in Parallel)
- Dimensions (WxLxH): 47 x 69 x 28mm per battery
- Maximum Continuous Discharge : 35C (182A)
- Maximum Burst Discharge : 70C (364A)
IMPORTANT:
1) You will need a Li-Poly specific charger to charge the pack (NiMH or NiCD only chargers WILL NOT WORK!)
2) You must not over discharge the Li-Poly battery pack.
3) Read the instructions carefully before operating this battery.
NOTE:
When using high energy Li-Polymer Batteries, please do not
over-discharge or over-charge batteries as this will result in over
heated batteries. Discharging capacity can't exceed 80% of the max
capacity of the pack after full charging to ensure a good cycle
performance. It is recommended to fully charge a brand new battery
before using and only discharge the battery 50% for first 5 cycles.
Always monitor race time and/or set a low voltage warning on ESC (End
voltage cannot be lower than 3.2v per cell) Do not use the battery that
has too low a voltage.
Do not expose batteries to sunshine or
store/charge batteries at the temperature above 35°C or in a closed
car. The high temperature environment could cause damage to the pack or
make it burst. If the battery becomes hot while fast charging, high
current discharging or racing, do not charge the battery until it has
cooled completely. Wait about 20 mins, then inspect prior to recharging.
ProTek R/C is an A
Main Hobbies brand.
|
