ProTek RC Li-Poly KO/JR Car Transmitter Battery Pack (11.1V/2300mAh)

This is a Li-Poly 2300mAh transmitter battery pack from ProTek R/C that fits the KO Helios and JR Z-1 transmitters. This light weight Li-Poly transmitter battery is designed to reduce the overall weight of your transmitter, which is great for those long main events! The overall weight of your transmitter will be significantly reduced over the use of typical NiMh receiver packs (134 grams compared to 225 grams for eight typical NiMH AA batteries!). Try to hold a pack of eight traditional AA size batteries and compare it with this Li-Poly Transmitter pack. The feeling is just awesome, and you get an incredible 9 to 10 hours of run time!

Aircraft Transmitter Compatability
This battery pack is compatible with some Futaba and JR aircraft and helicopters transmitters with modifications. For Futaba air transmitters, you will need to swap the polarity of the positive and negative leads on this battery, as the KO radios use the reverse polarity compared to Futaba radios. You can use a small Exacto style #11 blade to pop up the connectors holding the pins in place, so you can remove them and swap them around.

For JR aircraft transmitters that use the small white battery connector, you can use the ProTek R/C transmitter adapter (PTK-5221) to adapt this battery for some JR air transmitters. Once again you will have to follow the instructions above to reverse the polarity of the power leads on this battery to use it in a JR air transmitter.

Runtime:
Don’t be thrown off by the capacity rating of Li-Poly battery packs, as you will get awesome runtime out this pack! Given that Li-Poly battery packs provide a higher nominal voltage (11.1V nominal), the actual capacity of the battery pack when compared to a typical NiMH battery pack (9.6V nominal) is about 15% more than the rated value (so this pack would be about the same as a 2700mAh NiMH pack in total capacity).

How should the battery be inserted into the transmitter?
A foam pad should be used to pad the transmitter battery area and stop the battery from moving around. It will fit into the transmitter battery housing with the battery sitting on it, and then, while pressing lightly on the battery, slide the cover over the battery. A second piece of foam can be used if you wish to sandwich the battery between the two pieces of foam as necessary for a solid fit.

IMPORTANT:
1) You will need a Li-Poly specific charger to charge the pack (NiMH or NiCD only chargers WILL NOT WORK!)
2) You must not over discharge the Li-Poly battery pack below 9.0V.
3) Read the instructions carefully before operating this battery.

Specifications:

• Capacity: 2300 mAh
• Transmitter Run time: 9 to 10 hours
• Weight: 134 grams
• Li-Po cell arrangement: 3S1P
• Norminal voltage: 11.1 Volts
• Discharge capability: 3C (6.9A max)
• Dimension(mm): 110 x 28 x 21mm
• Connector: JR type connector

This product was added to our catalog on May 14, 2007