 This is the EBMods Combo Flywheel Puller/Wrench. This incredibly useful tool is a flywheel wrench, and puller in one! Designed and manufactured in the USA, the flywheel wrench will fit 2, 3 and 4 shoe flywheels, and the puller will work with flywheels between 28mm to 38mm in diameter. When you want a two-in-one solution that takes up less space in your pit box, this tool is a great choice.
Features:
- Made in the USA
- Fits 28mm-38mm flywheels
- Hard anodized black
- Includes 1/4" hex key, 3mm crank screw and small grease pack
Instructions: Remove the clutch bell, bearings and flywheel nut from the engine. Install the crank screw, and then apply grease to the tip of the puller. Install the puller over the flywheel and turn the T-handle clockwise to apply pressure to the flywheel, slowly keep turning until you hear or feel the flywheel release. On stubborn flywheels you may need to tap the flywheel when under pressure to shock the release.
NOTE: To prevent possible damage to the end of the crankshaft, always install the crank screw into the end of the crankshaft and apply grease to the tip of the puller.
|
