 This is the EBMods Flywheel Puller. The EBMods flywheel puller fits any 28mm-37mm flywheel. This puller is manufactured in the USA, and has been hard anodized black with a stainless steel T-handle. Includes 3mm crank screw and small packet of grease.
Features:
- Made in the USA
- Hard anodized black
- Stainless steel T-handle
- Includes 3mm crank screw and grease packet
Instructions: Remove the clutch bell, bearings and flywheel nut from the engine. Install the crank screw, and then apply grease to the tip of the puller. Install the puller over the flywheel and turn the T-handle clockwise to apply pressure to the flywheel, slowly keep turning until you hear or feel the flywheel release. On stubborn flywheels you may need to tap the flywheel when under pressure to shock the release.
NOTE: To prevent possible damage to the end of the crankshaft, always install the crank screw into the end of the crankshaft and apply grease to the tip of the puller.
|
